This is where you can configure an optional sender address to be used instead of the one otherwise automatically selected for the destination address.
If you have configured loopback addresses, you can specify them here as source address.
Telnet path:/Setup/WLAN/RADIUS-Access-Check
Possible values:
- Name of the IP networks whose address should be used
- "INT" for the address of the first intranet
- "DMZ" for the address of the first DMZ
- LB0 to LBF for the 16 loopback addresses
- Any valid IP address
Default: Blank
Note: If there is an interface named "DMZ", then its address is used.