Here you can optionally configure a sender address to be used instead of the one used automatically for this destination address. If you have configured loopback addresses, you can specify them here as sender address.
SNMP ID: 2.27.11
Telnet path: /Setup/Mail
Possible values:
- Name of the IP networks whose address should be used
- "INT" for the address of the first intranet
- "DMZ" for the address of the first DMZ
- LB0 to LBF for the 16 loopback addresses
- Any valid IP address
Default: Blank
Note: If there is an interface called "DMZ", its name will be taken in this case.