As of LCOS 10.80, accounting has been expanded. Along with support for IPv6, a new function has been added to display the current data throughput of individual stations or logical interfaces on the network. This function is particularly suitable for analyzing which station on the network is currently causing which data traffic. For example, this allows stations that are using the Internet connection to be identified, or to see how much traffic is running via which interface at the current time.
For performance reasons, it is recommended to only activate this function while the analysis is running and to deactivate it again afterwards. For more extensive traffic monitoring, Netflow is recommended in conjunction with an external collector.
To use the analysis function, use the command line and set the "Operating" item under /setup/accounting to "Yes".Set the "Intermittent-Reporting-Interval" to a small value in seconds, e.g. 5 seconds.
To deactivate the function again after the analysis, set the "Active" switch to "No".
To display the current throughput per user, use the command "show accounting users"
show accounting users Username Interface Rx-Total Tx-Total Rx-IPv4 Tx-IPv4 Rx-IPv6 Tx-IPv6 ======================--------------------------------------------------------------------- 192.168.1.7 INTERNET 0 Bit/s 115 Bit/s 0 Bit/s 115 Bit/s 0 Bit/s 0 Bit/s 192.168.1.9 INTERNET 9.38 KBit/s 3.92 KBit/s 9.38 KBit/s 3.92 KBit/s 0 Bit/s 0 Bit/s Next update of accounting bandwidth data in: 3s
As an alternative to the show command, the status table /Status/Accounting/User-Bandwidth-Usage can also be accessed.
The show command has a number of options that can be displayed by entering ?:
> show accounting ?
Displays short-term bandwidth usage statistics based on accounting.
NOTE: Accounting must be enabled and the Intermittent-Reporting-Interval must be set. All bandwidth data is updated according to that interval.
USAGE:
show accounting-bandwidth <COMMAND> [FLAGS]:
COMMANDS:
interfaces: Displays accounted bandwidth usage per interface
users: Displays accounted bandwidth usage per user per interface
FLAGS:
-bps: Displays all data as bps without decimals
-kbps: Displays all data as kbps with 3 fixed decimal places
-mbps: Displays all data as mbps with 3 fixed decimal places
-gbps: Displays all data as gbps with 3 fixed decimal places
NOTE: You can only choose one of the unit display flags. If none is given, the correct output unit is automatically determined. All numbers are given with 3 significant digits.
-compact: Reduces output to bandwidth usage totals per traffic direction
-totals-only: (Only for command 'users') Does not show bandwith usage per interface, but as a total value
Examples:
"show accounting interfaces" shows the load or current data throughput of the interfaces. This information can also be found in the /Status/Accounting/Interface-Bandwidth-Usage table
With the command "repeat 5 show accounting users" on the CLI you can have the command displayed automatically every 5 seconds.
