In LANconfig, configure Ethernet OAM according to IEEE 802.3ah under
.
- Interface
- Name of the interface.
- OAM interface enabled
- Enables/disables OAM on the respective interface.
- Mode
-
Defines the mode (Active/Passive) for the respective interface.
- Active
- The passive side (usually the CPE side) responds to the OAM packets (OAMPDUs) sent by the sender.
- Passive (Default)
- The active side (usually the internet provider) sends the OAM packets (OAMPDUs) to the receiver.
- Remote loopback supported
- Defines whether the device can be placed into loopback mode by the remote side. In loopback mode, the device disables forwarding and sends all received packets back on the interface. The packet is sent back exactly as it was received, with no mirroring of MAC or IP addresses.
- MIB retrieval supported
- Defines whether the device allows the remote side to retrieve specific status values or counters from the device via packets.
The following two commands are supported on the CLI: