Here you have the option to configure a sender address for the device to use in place of the one that would otherwise be used automatically for this target address.
If you have configured loopback addresses, you can specify them here as source address.
Note: If there is an interface named "DMZ", then its address is used.
- SNMP ID:
- 2.12.29.11
- Console path:
- Setup > WLAN > RADIUS-Access-Check
- Possible values:
- Name of the IP networks whose addresses are to be used.
- "INT" for the address of the first intranet.
- "DMZ" for the address of the first DMZ.
- LB0 to LBF for the 16 loopback addresses.
- Any valid IP address.
- empty
- Default:
