Here you have the option to configure a sender address for the device to use in place of the one that would otherwise be used automatically for this target address. If you have configured loopback addresses, specify them here as the respective source address.
Note: If the source address set here is a loopback address, then the device will use this unmasked even for remote stations that are masked.
The device accepts addresses in various input formats:
- Name of the IP network (ARF network), whose address should be used.
- "INT" for the address of the first intranet.
- "DMZ" for the address of the first DMZ (caution: If there is an interface called "DMZ", then the device takes its address).
- LB0…LBF for one of the 16 loopback addresses or its name
- Any valid IPv4 or IPv6 address
- SNMP ID:
- 2.26.11.2
- Console path:
- Setup > NTP > RQ-Address
- Possible values:
Max. 16 characters from [A-Z][0-9]@{|}~!$%&'()+-,/:;<=>?[\]^_.
- Default:
- empty
