Here you can optionally specify a loopback address for the device to use as the target address instead of the one that would normally be selected automatically.
Note: If the list of IP networks or source addresses contains an entry named 'DMZ', then the associated IP address will be used.
Important: If the source address set here is a loopback address, this will be used unmasked even on masked remote clients.
- SNMP ID:
- 2.2.35.10
- Console path:
- Setup > WAN > L2TP-Endpoints
- Possible values:
- Valid entry from the list of possible addresses.
- Name of the IP networks whose addresses are to be used.
- "INT" for the address of the first intranet
- "DMZ" for the address of the first DMZ
- LB0 to LBF for the 16 loopback addresses
- Any valid IP address
- empty
- Default:
