Enables the WLC to provide all new APs with a configuration, even those not in possession of a valid certificate.
Enables the WLC to provide a certificate to all new APs without a valid certificate. One of two conditions must be fulfilled for this:
- A configuration for the AP is entered into the AP table under its MAC address.
- The option "Automatically provide APs with the default configuration" is enabled.
Note: Combining the settings for auto-accept and default configuration can cater for a variety of different situations for the setup and operation of APs:
- Auto-Accept ON, Default-Configuration ON
- Rollout phase: Use this combination only if you can be sure that no APs can connect unintentionally with the LAN and thus be accepted into the WLAN infrastructure.
- Auto-Accept ON, Default-Configuration OFF
- Controlled rollout phase: Use this combination if you have entered all of the approved APs into the AP table along with their MAC addresses, assuming that these are to be automatically accepted into the WLAN infrastructure.
- Auto-Accept OFF, Default-Configuration OFF
- Normal operation: No new APs will be accepted into the WLAN infrastructure without the administrator's approval.
- SNMP ID:
- 2.37.6
- Console path:
- Setup > WLAN-Management
- Possible values:
- No
- Yes
- Default:
- No
