To configure the DECT base station in LANconfig, go to and add a new entry to the table.
Note: If auto-provisioning is to apply for all of the LANCOM DECT 510 IPs, or if they should all be configured the same, there is no need for any further entries in this table. The default entry takes care of everything.
- Name
- Specify a unique name for this base station here.
- MAC address
- Enter the MAC address of the base station.Note: If you wish to permit communications with any MAC address, enter 00:00:00:00:00:00 (default).
- Network name
- Here you optionally specify a network name that is displayed with the base station in the network.
- Routing tag
- The interface tag allows you to restrict the auto-provisioning of LANCOM DECT base stations to a specific network. This is particularly useful if your network contains IP addresses that are open to the public (e.g. via a Public Spot or DMZ). This restriction prevents SIP access credentials for the DECT base station from being unintentionally transmitted to third-party devices. Note: If you wish to use this service for all networks, enter the routing tag "0" here.
To configure the DECT handsets in LANconfig, go to and add a new entry to the table.
- Base station name
- Here you select the base station where the corresponding handset is registered.
- Index
- Enter here the number of the corresponding handset (e.g. "0" for handset 1, "1" for handset 2, etc.).
- SIP user
- Select the phone number of the handset here.
- Handset name
- Here you set the name to be shown in the display of the handset.
- Display name
- Here you set the name to be sent to a caller.
- Voice mailbox
- Enter the phone number of your voice mailbox here. This phone number is dialed by pressing and holding the button "1" on the handset.
