This table is used to configure specific network profiles that are assigned with APs that must not be automatically configured by the WLC by means of DHCP. In this way you set which specific IP parameters are used by an AP.
- Name
- Name of the IP parameter profiles.
- Inheritance
- Selection of an IP parameter profile defined earlier and from which the settings are to be inherited (see Inheritance of parameters).
- Domain name
- Name of the domain (DNS suffix) which is to use this profile.
- Netmask
- Netmask of the profile
- Default gateway
- The gateway used by the profile as standard.
- DNS default
- The DNS (Domain Name System) to be used by the profile.
- DNS backup
- Second, alternative DNS if the first is unavailable.
- Start address
- The start of the IPv4 address range from which a new AP receives an IP address if the WLC can allocate an assignment group to the AP and you have not defined a specific IP address for the AP in the AP table.
- End address
- The end of the IPv4 address range from which a new AP receives an IP address if the WLC can allocate an assignment group to the AP and you have not defined a specific IP address for the AP in the AP table.
For further information on assignment groups, please refer to the section IP-dependent auto configuration and tagging of APs.
